Sleepers are long pieces of wood placed on the basement slab that support the subfloor.
Sleeper floor basement.
Panel systems are also thinner than a sleeper floor so they add less height to the floor assembly an important benefit in height challenged basement rooms.
Cure the moisture problem before you install the floor.
Protect your new basement flooring by using subfloor sleepers.
Glued and ramset into concrete.
The ceiling is 7 feet 4 inches high which is typical for basements in older homes.
However because wood is a naturally porous substance that will absorb moisture when used as a basement subfloor these materials are often installed on mini joists known as sleepers which allow it to sit above a concrete pad.
Headroom especially in a basement may be at a premium.
2x4 sleepers installed on center every 12 16 inches and fastened down with rigid foam insulation 1 1 2 inch thick placed between the sleepers.
1 pound of 1 1 2 inch deck screws.
1 rigid foam glued to concrete between sleepers both for insulation as well as keeping cold air from hitting the concrete avoiding mold.
While most floors are relatively level some are purposefully constructed on a grade such as garage floors or basement floors that slope toward a floor drain.
During a remodel or a garage conversion it s standard practice to level a sloping floor before installing new floor covering.
Subfloor panels offer much easier installation than the traditional technique of nailing down 2x4 sleepers over the concrete and covering them with plywood.
Subfloor sleeper are used in basements to protect certain types of flooring such as laminate hardwood and carpet.
To compare the cost of a plywood subfloor system vs.
The intended finish flooring can be of any type.
Most basements have concrete floors which have the potential to draw moisture.
Moisture can cause floors to warp and provide a breeding ground for mold.
3 4 subfloor screwed glued to sleepers.
Purchase 1 pound of 16d framing nails for every 20 square feet of floor.
Plywood fastened to the sleepers.
A dricore system consider a basement with low moisture problems and an area of 675 square feet.